Project Battle Angel Alita – Full Build Log, Video & Benchmarks

Installation and Setup

WaterRam RGB Installation

Mounting the Radiator and Reservoir/Pump Combo

Power Supply Installation

Mounting the Riing 14 Trio RGB Fans

Installing the Motherboard

Adding the Hard Tubes (PETG 16mm OD)

These are the cleanest hard tubes I’ve done in years. Not bad … I guess being veteran helps 😛

TT Sync Controller Installation and Cable Management

Cable management is also very important … This is the best I could do so far 😛  There’s a total of around 13 RGB devices (fans/accessories) from Thermaltake. These are all connected to three TT Sync Controllers. It literally took me a whole day!

Quick Page Reference

1. Main page – Introduction and Components
2. Alita’s Arm – Paint Job
3. Hard Tube bending
4. Components – Motherboard, CPU Waterblock,
5. Components – WaterRam RGB, Patriot Viper VPN100 
6. Components – Riing 14 Trio RGB Fans, PSU, Radiator, Pump & Reservoir
7. Components – ZOTAC Gaming GeForce RTX 2080 AMP (with SLI bridge)
8. Modding the Thermaltake Level 20 GT ARGB chassis
9. Motheboard Installation and Watercooling Setup
10. Graphics Card Installation
11. Leak Test and RGB Lighting Check
12. Benchmarks and Temperatures
13. The Finish Item & Final Thoughts